Correct PSU Power Supply
Return to printer solutions | General questions
Your Magicard printer must only be used with the correct Power Supply.
- The wrong PSU can:
- Cause Faint or Light Printing: Light printing
- Create errors (commonly 16:00 Can’t lift head: Can’t lift print head)
- Permanently damage your printers Controller PCB
- Invalidate your printers warranty
The PSU must be exactly as shown below:
Direct to Card Printers
1st generation Rio Pro & All 2nd generation printers
*Pronto ONLY if the serial number does NOT contain a Letter, and is formatted as just 8 digits, like this: 12345678
The information on this page will help you identify which electronics version your Pronto was built with.
- Manufacturer: SUNPOWER
- DC Output: 24V 3.75A
- Yellow 90w tag
- Part Number: E9372
The label on the PSU should be like this:
1st Generation Pronto & All Enduro models
*Pronto ONLY if the serial number DOES contain a letter, like: 12F1234
The information on this page will help you identify which electronics version your Pronto was built with.
- Manufacturer: SUNPOWER
- DC Output: 24V 2.5A
- White 60w tag
- Part Number: P1-0034/R
The label on the PSU should be like this:
All printers can connect to your computer with a standard USB cable:
Global support centres
UK
Waverley House Hampshire Road Granby Industrial Estate
Weymouth, DT4 9XD
United Kingdom
USA
148 E. Stiegel St
Manheim, 17545
United States
Middle East
5WB (West Wing) Office 446
Dubai Airport Free Zone, 371564
United Arab Emirates
